Easy to install crown molding around the ceiling of the room can really improve the look and decor of your home.
Steps for easy to install crown molding:
Measure the length of each wall.
A long molding is awkward to handle, difficult to measure and precisely cut. It is easier to install it first because the first piece has a square cut at both ends – no response.
 |
 |
| Polyurethane gothic crown molding | Flexible inside corner crown molding |
Learn more our crown molding
Set the miter saw to a 45° angle.
In order to resist and outer angle bevel cutting, you must shape the crown mold – tilted to the right angle – against the saw fence. The pencil line on the bed or fence can help you place the crown correctly, but the fence extension and the stop can make the positioning fast and bulky.
Position the bottom of the molding against the saw fence and table.
Cut an overcoat along the edge of the beveled edge. Hold the angle of the saw, cut on the back of the mold surface. There are many molded products, you have to cut off a part to get another part.
Tilt the molding so the back is flush with the saw fence.
By processing the end and fixing it in place, mark the length of the outer corner piece. To get the right angle, use the crown of the crown. Draw a slash on the crown to indicate the chamfering direction.
Cut the crown molding to length.
Accurate measurement using two steps. Start a mark from the corner. Then measure from another corner to the mark and add two measurements.
 |
 |
| GM-9833 Polyurethane crown ceiling molding | GM-0133 Decorative ceiling crown molding |
Learn more our plain crown molding
Hold the molding on the wall, and nail it in place to the studs.
Then measure from another corner to the mark and add two measurements.
In order to prepare, the oblique cut position on the bottom edge of the crown-shaped article is measured and marked from the square end.
Fill the nail holes with putty, and caulk the joints and edges.
Fill and sand all the nail holes, and then according to the need for material and paint. Finally, remove the tape. Do not wait too long, even the painter’s tape will pull off the paint if it leaves for a few weeks. Also, make sure to cut the tape and drop the fresh paint on the crown so that the new paint will not be pulled with tape.
Paint the crown molding and allow to dry.
Finally, remove the tape. Do not wait too long, even the painter’s tape will pull off the paint if it leaves for a few weeks. Also, make sure to cut the tape and drop the fresh paint on the crown so that the new paint will not be pulled with tape.
Contact info:customer.en@goodware.com.tw
